Dell Vostro 1200 (Early 2009) - Manual (Page 104)

104 System Setup Program
5 When the boot device list appears, highlight the device from which you
want to boot and press <Enter>.
The computer boots to the selected device.
The next time you reboot the computer, the previous boot order is restored.
Enabling the Infrared Sensor
1 Press <Alt><p> until you locate Infrared Data Port under Basic Device
Configuration.
NOTE: Ensure that the COM port that you select is different from the COM port
assigned to the serial connector.
2 Press the down-arrow key to select the Infrared Data Port setting, and
press the right-arrow key to change the setting to a COM port.
3 Press <Esc> and then click Yes to save the changes and exit the system
setup program. If you are prompted to restart your computer, click Yes.
4 Follow the instructions on the screen.
5 After the infrared sensor has been enabled, click Yes to restart the
computer.
After you enable the infrared sensor, you can use it to establish a link to an
infrared device. To set up and use an infrared device, see the infrared device
documentation and access the Help and Support Center (click Start→ Help
and Support).
book.book Page 104 Wednesday, December 12, 2007 10:32 AM