Display, Display assembly, Removing the display assembly – Dell Inspiron Mini 10v (1011, Mid 2009) User Manual
Page 15
Back to Contents Page
Display
Dell™ Inspiron™ 1011 Service Manual
Display Assembly
Removing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the palm rest (see
Removing the Palm Rest
).
5.
Remove the hard drive (see
Removing the Hard Drive
).
6.
Remove the palm rest bracket (see
Removing the Palm Rest Bracket
).
7.
Remove the USB and SIM card board (see
Removing the USB and SIM Card Board
).
8.
Remove the AC adapter connector (see
Removing the AC Adapter Connector
).
9.
Remove the system board without removing the memory module and coin-cell battery (see
Removing the System Board
).
10.
Make note of the Mini-Card cable routing and pull the Mini-Card cables out of the computer base.
11.
Remove the two screws that secure the display assembly to the computer base.
12.
Lift and remove the display assembly from the computer base.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
display assembly
2
screws (2)