Dell Inspiron Mini 10v (1011, Mid 2009) - Manual (Page 27)

l One half Mini-Card slot - for Wireless Local Area Network (WLAN)
Removing the Mini-Card
1. Follow the instructions in Before You Begin .
2. Remove the battery (see Removing the Battery ).
3. Loosen the captive screw on the mini door.
4. Disconnect the antenna cables from the Mini-Card.
5. Release the Mini-Card by removing the two screws that secure the
Mini-Card to the system board connector.
6. Lift the Mini-Card out of its system board connector.
NOTE: Depending on the configuration of the computer when it was sold, the Mini-Card slots may or may not have Mini-Cards installed in them.
1 Mini-Card 2 screws (2) 3 antenna cable connectors (2)