Dell Inspiron Mini 10v (1011, Mid 2009) - Manual (Page 18)

6. Remove the four screws (two on each side) that secure the display panel brackets to the display panel.
Replacing the Display Panel
1. Attach the display brackets to the display panel by replacing the two screws on each side of the display panel.
2. Align the screw holes on the display panel with the holes on the display cover.
3. Replace the four screws that secure the display panel to the display cover.
4. Connect the camera cable to camera cable connector on the display cover.
5. Replace the display bezel (see Replacing the Display Bezel ).
6. Replace the display assembly (see Replacing the Display Assembly ).
Display Panel Cable
Removing the Display Panel Cable
1. Follow the instructions in Before You Begin .
2. Remove the display assembly (see Removing the Display Assembly ).
3. Remove the display bezel (see Removing the Display Bezel ).
4. Remove the display panel (see Removing the Display Panel ).
5. Turn over the display panel and place it on a clean surface.
6. Lift the conductive tape that secures the flex cable to the display board connector and disconnect the flex cable.
1 screws (4) 2 display cover
3 display panel 4 camera cable connector
1 screws (4) 2 display panel brackets (2)