Dell LATITUDE D400 - Manual (Page 46)

7. Open the display approximately 180 degrees.
8. Use a small flat-blade screwdriver or plastic scribe to lift the notched right edge of the center control cover, and pry
the cover loose from the bottom case.
9. Remove the two screws from the top of the keyboard.
10. Use the pull-tab to pull the keyboard up and out (toward the display) of the bottom case.
1 keyboard
2 keyboard pull-tab
3 screws (2)
4 securing tabs (5)
5 keyboard connector pull-
tab
6 interface connector (system
board)
11. Rest the keyboard face down on the palm rest.
12. Pull straight up on the pull-tab that is attached to the keyboard connector to disconnect the connector from the
interface connector on the system board.
To replace the keyboard:
1. Connect the keyboard connector to the interface connector on the system board.
2. Insert the five securing tabs on the keyboard into their respective slots in the palm rest.
3. Replace the two screws at the top of the keyboard.
4. Replace the center control cover and snap it down so that it is flush with the palm rest.