Dell OptiPlex SX280 - Manual (Page 76)

Printer Problems
Fill out the Diagnostics Checklist as you complete these checks.
Restoring Default Settings
Serial or Parallel Device Problems
Fill out the Diagnostics Checklist as you complete these checks.
properly.
l Unplug the power adapter from the computer and from the power outlet, wait one minute, and then reconnect the power adapter to
the power outlet and to the computer.
l Ensure that the electrical outlet is working by testing it with another device, such as a lamp.
If the power light is blinking yellow — The computer is receiving electrical power, but an internal power problem might exist.
l Ensure that all power cables are securely connected to the system board (see " System Board Components .")
Eliminate interference — Some possible causes of interference are:
l Power extension cables
l Too many devices on a power strip
l Multiple power strips connected to the same electrical outlet
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTE: If you need technical assistance for your printer, contact the printer's manufacturer.
Check the printer documentation — See the printer documentation for setup and troubleshooting information.
Check the printer cable connections —
l See the printer documentation for cable connection information.
l Ensure that the printer cables are securely connected to the printer and the computer.
Test the electrical outlet — Ensure that the electrical outlet is working by testing it with another device, such as a lamp.
Verify that the printer is recognized by Windows —
1. Click the Start button, click Control Panel, and then click Printers and Other Hardware.
2. Click View installed printers or fax printers.
If the printer is listed, right-click the printer icon.
3. Click Properties and click the Ports tab. For a parallel printer, ensure that the Print to the following port(s): setting is LPT1 (Printer
Port). For a USB printer, ensure that the Print to the following port(s): setting is USB.
Reinstall the printer driver — See the printer documentation for instructions.
To restore the computer's system settings to their default values —
1. Turn on or restart your computer.
2. When Press <F2> to Enter Setup appears in the upper-right corner of the screen, press <F2> immediately.
If you wait too long and the Microsoft® Windows® logo appears, continue to wait until you see the Windows desktop. Then shut
down your computer through the Start menu and try again.
3. Under System Management, select the Maintenance option and follow the directions on the screen.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.