Dell Dimension 8300 - Manual (Page 100)

100 A d d i n g Pa r t s
www
.dell.com | support.dell.com
8 Highlight Drive Configuration and press <Enter>.
9 Use the left and right arrows to change Diskette Drive A from Not Installed to
3.5 inch, 1.44MB.
10 Press <Enter>.
11 Highlight Integrated Devices (LegacySelect Options) and press <Enter>.
12 Make sure that the Diskette Interface entry is set to Auto. If necessary, use the left and
right arrows to set it to Auto.
13 Press <Enter>.
14 Press <Esc>.
15 Press <Enter> to save changes and exit.
The computer restarts.
See the documentation that came with the drive for instructions on installing any
software required for drive operation.
Closing the Computer Cover
1 Ensure that all cables are connected, and fold cables out of the way.
Gently pull the power cables toward you so that they do not get caught underneath
the drives.
2 Ensure that no tools or extra parts are left inside the computer.
3 Close the cover:
a Pivot the cover down.
b Press down on the right side of the cover until it closes.
c Press down on the left side of the cover until it closes.
d Ensure that both sides of the cover are locked. If not, repeat all of step 3.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
4 Connect your computer and devices to electrical outlets, and turn them on.