Dell Latitude E6400 XFR (Mid 2008) - Manual (Page 47)

Dell ™ Latitude™ E6400 XFR Service Manual
Page 47
6. Disconnect the finger print reader cable (optional), the speaker cable, and the touch pad cable from the
system board.
7. Lift the touch pad cable to reveal the contactless smart card cable underneath. Disconnect the contactless
smartcard cable from the system board.
8. Disconnect the GPS antenna and USB connector (optional, see Removing the GPS Card).
9. Unroute the GPS antenna and USB connector from the palm rest.
10. Turn the computer over and remove the four M2.5 x 8-mm screws on the bottom of the computer.
11. Remove the one M2.5 x 5-mm screw on the motherboard between the fan and the fan connector.
12. Turn the computer topside and remove the sixteen M2.5 x 8-mm screws on the top of the palm rest.
NOTE: There are four snap hooks located in front of the mouse touchpad as part of the base
assembly. These snap hooks may provide resistance during removal. To release the snaps,
lift the LCD edge, of the palm rest, until the snap release.
13. Lift the palm rest from the computer.
NOTE: The handle will fall off when the palm rest is removed.