Dell Alienware Area 51 R2 (Late 2014) - Manual (Page 86)

Removing the Front-bezel
Heat-sensor
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in Before Working Inside Your Computer .
After working inside your computer, follow the instructions
in After Working Inside Your Computer . For more safety best
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Prerequisites
1 Remove the stability foot .
2 Remove both the left and right side-panels. See “ Removing the Side
Panels ”.
3 Remove the PCI fan. See “ Removing the PCI fan ”.
Procedure
NOTE: After removing the PCI fan, locate the sensor on the fan shroud.
1 Lay the computer on the left side.
2 Press the release tab on the securing clip.
3 Pry out the chassis heat-sensor cable from the securing clip.
86