Local access to the command line interface, User’s guide, Mete red rac k pdu – Dell Metered PDU LED User Manual
Page 19
Advertising
USER’S GUIDE
Mete
red Rac
k
PDU
16
Local access to the command line interface
For local access, use a computer that connects to the Rack PDU through the serial port
to access the command line interface:
1 . Select a serial port at the computer and disable any service that uses that port.
2 . Connect the supplied serial cable from the selected serial port on the computer to
the serial port on the Rack PDU.
3 . Run a terminal program (e.g., HyperTerminal) and configure the selected port for
9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control.
4 . Press
E
NTER
, and at the prompts, enter your user name and password.
Advertising