Chassis intrusion switch, Removing the chassis intrusion switch – Dell Precision 360 User Manual
Page 19
Chassis Intrusion Switch: Dell Precision 360 Service Manual
file:///C|/infodev/2013/eDoc/ws360/SM/chsintr.htm[2/18/2013 12:39:37 PM]
Chassis Intrusion Switch
Dell Precision™ 360 Service Manual
Removing the Chassis Intrusion Switch
Resetting the Chassis Intrusion Detector
Replacing the Chassis Intrusion Switch
CAUTION:
Before performing any of the procedures in this section, follow the safety instructions in the
System Information Guide.
CAUTION:
To prevent static damage to components inside your computer, discharge static electricity from
your body before you touch any of your computer's electronic components. You can do so by touching an
unpainted metal surface on the computer chassis.
Removing the Chassis Intrusion Switch
1. Disconnect the chassis intrusion switch cable from the control panel on the front of the computer.
Note the routing of the chassis intrusion cable as you remove it from the chassis. Chassis hooks may hold the cable in
place inside the chassis.
2. Slide the chassis intrusion switch out of its slot, and remove the switch and its attached cable from the computer.
Mini Tower Computer