Replacing the power supply – Dell Precision 360 User Manual
Page 22
Power Supply: Dell Precision 360 Service Manual
file:///C|/infodev/2013/eDoc/ws360/SM/pwrsply.htm[2/18/2013 12:39:38 PM]
4. Slide the power supply toward the front of the computer approximately 1 inch.
5. Lift the power supply up and out of the computer.
Replacing the Power Supply
1. Slide the power supply into place.
2. Replace the two screws that secure the power supply to the back of the computer frame.
3. Reconnect the DC power cables.
4. On the desktop computer, reattach the power cables to the side of the hard drive.
5. Run the cables underneath the tabs, and press the tabs to close them over the cables.
6. Close the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
7. Connect your computer and devices to electrical outlets, and turn them on.