Replacing the system board – Dell Precision 360 User Manual
Page 24
System Board: Dell Precision 360 Service Manual
file:///C|/infodev/2013/eDoc/ws360/SM/sysbrd.htm[2/18/2013 12:39:38 PM]
Replacing the System Board
1. Transfer components from the existing system board to the replacement system board:
a. Remove the memory modules and install them on the replacement board.
CAUTION:
The microprocessor package and heat-sink assembly can get hot. To avoid burns, ensure that
the package and assembly have had sufficient time to cool before you touch them.
b. Remove the heat-sink assembly and microprocessor from the existing system board and transfer them to the
replacement system board.
2. Configure the settings of the replacement system board.
3. Set the jumpers on the replacement system board so they are identical to the ones on the existing board.
NOTE:
Some components and connectors on the replacement system board may be in different locations than the
corresponding connectors on the existing system board.
4. Orient the replacement board by aligning the notches on the bottom of the board with the tabs on the computer.
5. Slide the system board assembly toward the back of the computer until the assembly clicks into position.
6. Replace any components and cables that you removed from the system board.