Dell 2300 Wireless Broadband Router - Manual (Page 83)

No additional settings are required. Make sure that the settings listed above are correct for Cable Modem
connection.
DSL Static IP Settings
In the fields provided (listed below), enter the IP address, IP subnet mask, ISP gateway address, and Domain
Name Server (DNS) IP address provided by your ISP.
IP assigned by your ISP
IP Subnet Mask
ISP Gateway Address
Domain Name Server (DNS) IP Address
DSL PPPoE Settings
Point to Point Protocol over Ethernet (PPPoE) is a proposal specifying how a host PC interacts with a broadband
modem (i.e. xDSL, cable, wireless, etc) to access to the network. In many respects PPPoE is similar to the
"Dialup Networking" approach. If you have an DSL (PPPoE) Internet connection, enter the PPPoE user name
and password (Retype password to confirm.) provided by your ISP.
PPTP Settings
The following settings should be provided to you by your Internet Service Provider (ISP).
IP Address
Subnet Mask
Server IP Address
User Name
Password
If your ISP specifies that you use PPTP (Point-to-Point Tunneling Protocol) as your connection to the internet, you
cannot use the provided setup wizard to automatically setup your router. Remove the ethernet cable from the
back of the computer you currently connect with, and connect it to the internet port of your router. Connect the
ethernet cable provided to any of the 4 LAN ports, and the other end to your computer. Configure your
computer's ethernet adapter to obtain an address automatically. See Windows Help for information on how to
configure your computers network adapter.
Click the NEXT button to continue.
WARNING! If you are charged for your Internet Connection by the minute, unplug the network
cable from the Internet port on the Wireless Broadband Router when Internet access is no
longer desired.
Back to Top
Save & Apply
Use the Save & Apply page to submit all the network setting changes you have made. Click the Save & Restart button to
update the network configurations for your Wireless Broadband Router. New settings are written to the firmware, and the
Wireless Broadband Router reboots automatically.
NOTE: If you have wireless clients in your network, you must configure the clients' wireless network cards to match
the settings for the Wireless Broadband Router.
Back to Top
Back to Contents Page