Connector covers, Removing the connector covers, Replacing the connector covers – Dell Inspiron Mini Duo (1090, Late 2010) User Manual
Page 27
Back to Contents Page
Connector Covers
Dell™ Inspiron™ 1090 Service Manual
Replacing the Connector Covers
Removing the Connector Covers
1.
Follow the instructions in
Before You Begin
.
2.
Remove the system board (see
Removing the System Board
).
3.
Press the rubber tabs on the connector cover(s) and push it out of the slots on the computer base.
4.
Remove the connector cover(s) off the computer base.
Replacing the Connector Covers
1.
Follow the instructions in
Before You Begin
.
2.
Place the connector cover(s) in position.
3.
Press the connector cover(s) and push them through the slots in the computer base.
4.
Replace the system board (see
Replacing the System Board
).
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
connector covers (2)
2
slots in the computer base
3
rubber tabs (4)
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.