Dell 7130cdn Color Laser Printer - Manual (Page 20)

Network Basics
Dell 7130cdn Professional Color Printer
User Guide 20
Automatically Setting the Printer’s IP Address
If the printer is connected to a small established TCP/IP network without a DHCP server, use the
installer on the Software and Documentation CD to detect or assign an IP address to your printer.
Insert the Software and Documentation CD into your computer’s CD drive. After the Dell Installer
launches, follow the prompts for installation.
Note: For the automatic installer to function, the printer must be connected to an established
TCP/IP network.
Dynamic Methods of Setting the Printer’s IP Address
There are two protocols available for dynamically setting the printer’s IP address:
• DHCP (enabled by default on all Dell printers)
• AutoIP
You can turn on/off both protocols using the control panel, or use the EWS to turn on/off DHCP.
Note: You can view the printer’s IP address at any time. On the control panel, select
Information, press the OK button, select Printer Identification, then press the OK button.
Using the Control Panel
To turn on/off either the DHCP or AutoIP protocol:
1. On the control panel, select Printer Setup > Connection Setup > Network Setup >
TCP/IPv4 Setup, then press the OK button.
2. Select DHCP/BOOTP or AutoIP.
3. Press the OK button to turn the selection On or Off.
Using the EWS
To turn on/off the DHCP protocol:
1. Launch your Web browser.
2. Enter the printer’s IP address in the browser’s Address field.
3. Select Properties.
4. Select the Protocols folder on the left navigation panel.
5. Select TCP/IP.
6. Click the TCP/IP (v4) button.
7. In the BOOTP/DHCP Settings section, set the BOOTP/DHCP option to On or Off.
8. In the TCP/IP Settings section, enter the static IP address which may be different than the
DHCP or auto IP address listed. Check that the Network Mask and Router/Gateway address
are correct for your network.
9. Click the Save Changes button.