Dell Inspiron 8200 - Manual (Page 41)

Back to Contents Page
RJ-11/RJ-45 Module
Dell™ Inspiron™ 8200
Removing the RJ-11/RJ-45 Module
1. Follow the instructions in " Preparing to Work Inside the Computer ."
2. Remove the system board .
3. From outside the bottom case, push in and up on the RJ-11/RJ-45 module while pulling the side of the bottom case slightly outward. When the module
disengages, lift it out.
Replacing the RJ-11/RJ-45 Module
When replacing the RJ-11/RJ-45 module, hold both cables safely out of the way and snap the housing down into place. Then route the modem cable through
the vertical slot, through the appropriate posts, and out through the corner of the memory module/modem cutout.
NOTICE: Disconnect the computer and attached devices from electrical outlets and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by periodically touching unpainted metal on the computer.
NOTICE:
1 network cable
2 bottom case
3 RJ-11/RJ-45 module
4 modem cable
1 vertical slot