Dell Inspiron 8200 User Manual
Page 61
13.
Separate the network cable from the system board:
a.
First remove the network cable cover: Insert a narrow plastic scribe or small screwdriver just barely into the slot that faces the back of the
computer (do not insert the scribe far enough to catch on the wires inside), press down on the cover lightly to secure it, and pry upward to
release the cover.
b.
Disconnect the network cable. Do not pull on the cable wires. Instead, pry up the outer corner of the upper connector until the connectors start
to separate.
14.
Remove the three M2.5 x 4-mm captive-washer screws from the system board.
15.
Remove the M2.5 x 20-mm screw from the center of the LED board.
16.
Lift the front of the system board and work it out of the back panel.
If necessary to help release the system board, pull outward on the top of the plastic near the back left corner of the bottom case (see the small arrow at
the far left in the following figure).
1 network cable cover
1 outer corner of upper
connector
2 network cable