Display assembly, Removing the display assembly, Replacing the display assembly – Dell Latitude D530 (Early 2008) User Manual
Page 12
Back to Contents Page
Display Assembly
Dell™ Latitude™ D530 Service Manual
Removing the Display Assembly
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Remove the hinge cover (see
Hinge Cover
).
3.
Remove the keyboard (see
Keyboard
).
4.
Remove the captive screw that grounds the display cable.
5.
Disconnect the display cable from the display cable connector on the system board.
6.
Disconnect the three Mini-Card antenna cables (see
Mini-Card
).
7.
Disconnect the antenna cables from the display by holding the two gold antenna connectors on each connector and gently pulling them apart.
8.
Remove the four M2.5 x 5-mm screws from the display and remove the display from the computer.
Replacing the Display Assembly
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working inside the
computer.
1 M2.5 x 5-mm screws (4)
2 display cable grounding-wire screw 3 display cable pull-tab
4 display connector on system board 5 antenna cable connectors (3)