Dell Latitude D530 (Early 2008) - Manual (Page 14)

Display Panel
Removing the Display Panel
1. Follow the instructions in Before Working Inside Your Computer .
2. Remove the display assembly (see Removing the Display Assembly ).
3. Remove the display bezel (see Removing the Display Bezel ).
4. Remove the eight M2 x 5-mm screws in sequential order (four on each side of the display panel).
5. Lift the display panel out of the display back cover.
6. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: To help prevent damage to the system board, you must remove the main battery (see Before Working Inside Your Computer ) before you
begin working inside the computer.
1 display panel 2 M2 x 5-mm screws (8) 3 display back cover
1 pull-tab on bottom flex-cable connector 2 top flex-cable connector 3 display cable connector
4 inverter connector