Dell 1130 Laser Mono Printer - Manual (Page 20)

Only use an USB cable shorter than 3 m (118 in. ).
Windows
You can install the machine software using the typical or custom method.
The following steps below are recommended for most users who use a machine directly connected to your computer. All
components necessary for machine operations will be installed.
1. Make sure that the machine is connected to the computer and powered on.
If the “Found New Hardware Wizard” window appears during the installation procedure, click Cancel in close
the window.
2. Insert the supplied software CD into your CD/DVD drive.
The software CD should automatically run and an installation window should appear.
If the installation window does not appear, click Start and then Run. Type X:\Setup.exe, replacing “X” with
the letter which represents your CD/DVD drive. Click OK.
If you use Windows Vista, Windows 7 and Windows 2008 Server R2 click Start > All programs > Accessories
> Run.
Type X:\Setup.exe replacing “X” with the letter which represents your CD/DVD drive and click OK.
If the AutoPlay window appears in Windows Vista, Windows 7 and Windows 2008 Server R2, click Run
Setup.exe in Install or run program field, and click Continue or Yes in the User Account Control windows.
3. Click Next.
If necessary, select a language from the drop-down list.
4. Select Typical installation for a local printer. Then, click Next.
The Custom allows you to select the machine’s connection and choose individual component to install. Follow
the on-screen instructions.