Dell E228WFP Monitor - Manual (Page 25)

Using the OSD Menu
1. Push the MENU button to open the OSD menu and display the main menu.
D
Auto Adjust
Use this button to activate automatic setup and adjust menu. The following dialog appears on a black screen as the
monitor self-adjusts to the current input:
Auto Adjustment allows the monitor to self-adjust to the incoming video signal. After using Auto Adjustment, you can
further tune your monitor by using the Pixel Clock (Coarse) and Phase (Fine) controls under Image Settings.
Auto Adjust In Progress
NOTE: Auto Adjust will not occur if you press the button while there are no active video input signals
or attached cables.
E
Power Button and Indicator
Use the power button to turn the monitor on and off.
The green light indicates the monitor is on and fully functional. An amber light indicates power save mode.
NOTE: If you change the settings and then either proceed to another menu or exit the OSD menu, the monitor automatically saves those
changes. The changes are also saved if you change the settings and then wait for the OSD menu to disappear.
Main Menu for Auto Detect Analog (VGA) Input Main Menu for Auto Detect Digital (DVI) Input
or
Main Menu for Analog (VGA) Input Main Menu for digital (DVI) Input