Dell E228WFP Monitor - Manual (Page 4)

If you have VESA's DPM™ compliance display card or software installed in your PC, the monitor can automatically reduce its power consumption when not in
use. This is referred to as 'Power Save Mode'*. If input from keyboard, mouse, or other input devices is detected by the computer, the monitor automatically
'wakes up'. The following table shows the power consumption and signaling of this automatic power saving feature:
Activate the computer and 'wake up' the monitor to gain access to the OSD .
* Zero power consumption in OFF mode can only be achieved by disconnecting the main cable from the monitor.
Pin Assignments
15-pin D-Sub connector
24-pin Digital-Only DVI Connector
VESA Modes Horizontal Sync Vertical Sync Video Power Indicator Power Consumption
Normal operation Active Active Active Green 45 W (typical)
Active-off mode Inactive Inactive Blanked Amber Less than 2 W
Switch off - - - Off Less than 1 W
NOTE: The OSD only functions in the 'normal operation' mode. One of the following messages appears when the “menu” or “plus” buttons are pressed
when in Active-off mode.
1: Auto detect
In Power Save Mode
Press computer power button
or any key on keyboard or move mouse
or
2: Analog Input
In Power Save Mode
Press computer power button
or any key on keyboard or move mouse
or
3: Digital Input
In Power Save Mode
Press computer power button
or any key on keyboard or move mouse
This monitor is ENERGY STAR®-compliant as well as TCO '99 power management compatible.
Pin Number Monitor Side of the 15-pin Side Signal Cable
1 Video-Red
2 Video-Green
3 Video-Blue
4 GND
5 Self-test
6 GND-R
7 GND-G
8 GND-B
9 DDC +5V
10 GND-sync
11 GND
12 DDC data
13 H-sync
14 V-sync
15 DDC clock