Screw identification and tightening, Exploded view of computer – Dell Inspiron 7500 User Manual
Page 110
l
Dental pick
l
Small scribe or nylon flat blade
l
Nut drivers (5 mm and 5.5 mm)
Screw Identification and Tightening
Be careful not to scratch the computer plastic case by allowing screws to get between the disassembly surface and the plastic case. Dell suggests
a soft padded work surface.
Your computer contains many screws of various sizes. To help keep track of the screws, use a tackle or pill box as a storage device. Use Table 1
as a location template to store the screws during disassembly.
Table 1. Screw Identification and Location
Exploded View of Computer
Figure 10. Computer Components
NOTICE: The correct-length screw must be used when reinstalling a screw. Otherwise, hardware damage could result. Make sure
that the screw is properly aligned with its corresponding hole, and avoid overtightening.
NOTICE: During the removal and replacement procedures, you will see Kapton tape in many places on the computer. When
reinstalling or replacing parts, be sure to replace the Kapton tape correctly to retain the electrical protection and noise reduction
the tape provides.
4X K-head M3x3L
2X K-head, M2x2.5L
3X K-head, M2.5x3L
8X K-head M2x3L
4X pan head, M2.5x20L
1X 0143E SCR, M2.5x.45P+3FP-ZK
2X 7043E SCR, M2.5x.45+10FP-ZK-NL
6X 8043E SCR, 2.5x.45+6P-ZK-NL
8X 3319U SCR, M2x3, KSH, MSCR,
CPS, LKG
2X 7043E SCR, M2.5x.45+10FP-ZK, NL
2X 0300U SCR, 2.5x8, KSH, MSCR, CPS
8X 9200U SCR, M2x4, KSH, MSCR, CPS
1X K-head, M2.5x4L
4X flat head, M2x4L
4X binding head, M2.5x6L
4X binding head, M2.5x6L
4X binding head, M2.5x6L
6X K-head, M2.5x4L
1X K-head, M2.5x4L
2X K-head M2.5x4L
5X K-head M2.5x4L
4X K-head M2.5x4L
3X K-head M2.5x4L
5X K-head M2.5x4L
2X K-head, M2.5x4L
2X binding head, M2x5L
3X binding head, M2x5L
1X binding head, M2.5x6L
4X K-head, M2.5x4L
1X binding head, M2.5x10L
1X pan head, M2.5x20L
4X K-head, M2.5x4L
1X pan head, M2.5x20L
1X binding head M2.5x10L
1X K-head, M2.5x4L
3X K-head, M2.5x4L
1X K-head, M2.5x4L
4X pan head, M2x18L
1X binding head, M2.5x10L
1X K-head, M2.5x4L
2X K-head, M2.5x4L