Rj-11 card removal, System board removal, Rj-11 card – Dell Inspiron 7500 User Manual
Page 130: System board
4. Remove the 10-mm screw and 20-mm screw from the left hinge saddle and remove the saddle.
5. Disconnect the LED cable from connector J6 on the system board.
6. Remove the 6-mm screw from the plastic frame, remove any tape, and remove the plastic frame.
RJ-11 Card Removal
Figure 34. RJ-11 Card Components
1 4-mm screw
2 RJ-11 card
To remove the RJ-11 card (see Figure 34), perform the following these steps:
1. Remove the 4-mm screw securing the RJ-11 card to the system board.
2. Lift the card off the system board.
System Board Removal
Figure 35. System Board Components
This procedure assumes that you have removed the
and
. To remove the system board (see Figure 35), perform
the following steps:
1. Remove the three 4-mm screws from the bottom of the computer.
2. Remove the system board from the bottom case.
2 RJ-11 card
1 4-mm screws (3)
2 System board