Dell Inspiron 7500 - Manual (Page 127)

This procedure assumes that you have removed the palmrest assembly from the base assembly. To remove the hard-disk drive heat shield (see
Figure 29), perform the following steps:
1. Place the palmrest assembly face down.
2. Remove the five 4-mm screws securing the hard-disk drive heat shield.
3. Remove the hard-disk drive heat shield.
Speaker Removal
Figure 30. Speaker Components
This procedure assumes that you have removed the palmrest assembly from the base assembly and that you have removed the hard-disk drive
heat shield and touch pad assembly . To remove the speakers (see Figure 30), perform the following steps:
1. Remove any tape securing the speaker cables.
2. Remove the three 4-mm screws securing the left speaker cover.
1 4-mm screws (5)
2 Hard-disk drive heat shield
1 Right speaker
2 Right speaker cover
3 Speaker cables (2)
4 4-mm screws (5)
5 Left speaker cover
6 Left speaker
7 Speaker wiring harness
8 Display latch
NOTE: Before removing the speaker cables and wire harness, be sure to note their routing through the slots and pins so you
can correctly reinstall the components.