Dell Inspiron 7500 - Manual (Page 2)

Back to Contents Page
13.3- Inch LCD Brackets and Carrier Tray Removal: Dell™ Inspiron™ 7500
This procedure assumes that you have removed the front bezel and the 13.3-inch LCD panel . To remove the brackets from the LCD panel, follow
these steps:
1. Detach the LCD wire harness from connector CN1 on the top left side of the inverter board.
2. Remove the (4) 6-mm screws from the sides of the mounting brackets.
3. Remove the brackets from the LCD panel.
To remove the 13.3-inch LCD panel from the carrier tray, follow these steps:
1. Remove any Kapton tape covering the CCFL cable.
2. Gently pull the cable out of its connector.
3. Remove any Kapton tape from the LCD wire harness.
4. Disconnect the LCD wire harness from the LCD panel.
5. Lift the LCD panel out of carrier tray.
Back to Contents Page
NOTICE: The metal on the carrier tray is sharp. Be careful not to cut yourself.