Dell PowerEdge T310 - Manual (Page 47)

About Your System
47
Quad rank DIMM
detected after
single rank or
dual rank DIMM in
socket.
Invalid memory
configuration. Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module Installation
Guidelines" on page 108.
Read fault
Requested sector
not found
The operating system cannot
read from the hard drive,
optical drive, or USB device,
the system could not find a
particular sector on the disk,
or the requested sector is
defective. Replace the optical medium,
USB medium or device.
Ensure that the
SAS backplane, USB,
or SATA cables are
properly connected.
See "Troubleshooting a USB
Device" on page 148,
"Troubleshooting an Optical
Drive" on page 158,
or "Troubleshooting a Hard
Drive" on page 160 for the
appropriate drive(s) installed
in your system.
SATA Portx
device not found
There is no device connected
to the specified SATA port. Information only.
SATA port x
device
auto-sensing
error
SATA port x
device
configuration
error
SATA port x
device error
The drive connected to the
specified SATA port is faulty. Replace the faulty drive.
Table 1-3. System Messages (continued)
Message Causes Corrective Actions
book.book Page 47 Wednesday, August 19, 2009 4:40 PM