Dell PowerEdge T310 - Manual (Page 81)

Installing System Components
81
Front Bezel
NOTE:
If you are removing or installing a hot-swappable hard drive, the system
may remain turned on and in the upright position during removal of the front bezel.
If you are removing or installing any other system component(s), the system should
be turned off and placed in the orientation shown in Figure 3-1.
Removing the Front Bezel
1 Using the system key, unlock the front bezel (if locked).
2 Slide the release latch in the direction of the arrow and rotate the top end
of the bezel away from the chassis. See Figure 3-2.
3 Lift the bezel away from the chassis.
Figure 3-2. Removing or Replacing the Front Bezel
1 release latch 2 bezel
3 bezel key lock 4 bezel tabs (2)
5 tab slots (2)
1
2
4
3
5
book.book Page 81 Wednesday, August 19, 2009 4:40 PM