Dell Adaptec U320 SCSI Raid 0 or 1 Controller Card - Manual (Page 24)

message appears:
Do you want to make this array bootable?
5. Select Yes if you want to make the array bootable. The following message appears:
Create Array?
6. Select Yes. The following message appears:
Are you sure?
7. Select Yes and press <Enter> to create a RAID 0 array. After your array is created, you will automatically return
to the Main menu.
Creating RAID 1 Arrays
There are two ways to create a RAID 1 array. You can create a new RAID 1 array or you can migrate from an existing
single drive to a RAID 1 array. To create a RAID 1 array using either option:
1. From the Select RAID Type window, select RAID-1. Select the hard drives you want using the Spacebar to
toggle, then press <Enter>. The RAID-1 Build Option window appears.
2. Select an option and press <Enter>.
The options you can choose are:
Create new RAID-1—is the default option.
Copy from (11) to (12)—copy from a source drive to a target drive if the source is equal to or smaller
than the target.
Copy from (12) to (11)—copy from a source drive to a target drive if the source is equal to or smaller
than the target.
NOTE: If a valid partition table or boot block is detected in the target drive, you will get a warning message that
the information will be destroyed.
3. Assign a RAID name by entering up to 15 alphabetic or numeric characters, then press <Enter>. The following
message appears:
Do you want to make this array bootable?
4. Select Yes if you want to make the array bootable. The following message appears:
Create Array?
5. Select Yes. The following message appears: