System requirements, Raid storage management utilities – Dell Adaptec U320 SCSI Raid 0 or 1 Controller Card User Manual
Page 3
RAID Storage Management Utilities
The Adaptec U320 SCSI RAID 0 or 1 includes the following software tools to manage your storage subsystem:
RAID Storage Manager—Browser based storage management software that provides all of the creation,
management, data logging, messaging, and control needed to manage arrays on the operating system. For details,
refer to the RAID Storage Manager documentation.
BIOS Configuration utility—Configuration utility that is part of the controller's built-in BIOS-based code. The
utility can be started by pressing <Ctrl><A> during BIOS startup. For details, refer to "
System Requirements
The following system requirements are discussed:
Storage Requirements
SCSI Drive Requirements
Hardware Requirements
Storage Requirements
RAID Storage Manager and the Adaptec U320 SCSI RAID 0 or 1 device drivers require 20 MB of disk space.
NOTE: This information is provided as a guide for allocating resources on your system. Space requirements
may vary in subsequent releases. Allocate more room on your hard drive if in doubt.
SCSI Drive Requirements
While the Adaptec U320 SCSI RAID 0 or 1 is designed to work with Ultra320 and Ultra160 SCSI hard disk drives, it
will operate, at a reduced level of performance, with all legacy Ultra2, Ultra, and Single-Ended (SE) SCSI devices. Use
of High Voltage Differential (HVD) devices is not supported.
More details about configuring and using SCSI drives are available in "
Hardware Requirements
Specification
Requirement
Voltage Requirements
5-V/33 MHz and 3.3V/66-MHz
System Bus Interface Requirements PCI/X 133 MHz
Mouse
Yes
Monitor
SVGA color monitor using a resolution of at least 800 x 600 with 16-bit color