Installing the network connector, Removing the coin-cell battery – Dell Precision M2800 (Early 2014) User Manual
Page 22
Advertising
Installing the Network Connector
1.
Align the network connector to its position on the computer.
2. Place the network-connector bracket on the network connector.
3. Tighten the screw to secure the network-connector bracket to the computer.
4. Route the cable through the routing channel.
5. Connect the cable to the system board.
6. Install:
a.
b.
c.
After Working Inside Your Computer
.
Removing the Coin-Cell Battery
1.
Before Working Inside your computer
2. Remove:
a.
b.
3. Disconnect the coin-cell battery cable, pry the coin-cell battery upward, and remove the coin-cell
from the computer.
22
Advertising