Installing the power connector, Removing the heat-sink assembly – Dell Precision M2800 (Early 2014) User Manual
Page 24
Advertising
Installing the Power Connector
1.
Align the power connector to its position in the computer.
2. Place the power-connector bracket on the power connector.
3. Tighten the screw to secure the power-connector bracket to the computer.
4. Route the cable through the routing channel.
5. Connect the cable to the system board.
6. Install:
a.
b.
c.
After Working Inside Your Computer
.
Removing the Heat-Sink Assembly
1.
Before Working Inside Your Computer
2. Remove:
a.
b.
3. Disconnect the fan cable and remove the screws that secure the heat-sink assembly to the system
board.
24
Advertising