Palm rest and display cover inserts, Palm rests, Display cover – Dell Inspiron 4150 User Manual
Page 23
Back to Contents Page
Palm Rest and Display Cover Inserts
Dell™ Inspiron™ 4150
Palm Rests
1.
Save and close any open files, exit any open programs, and shut down the computer.
2.
If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions.
3.
Keep the display open and tilt the computer back so that you can access the bottom of the computer.
4.
Slide and hold the latch release on the left side, and remove any device installed in the module bay.
5.
Slide and hold the latch release on the right side, and remove any battery installed in the battery bay.
6.
Locate the orange palm rest removal buttons. Firmly press the buttons with the eraser end of a pencil (or a dull utensil smaller than your finger) to
release the palm rests.
7.
Remove the palm rests.
8.
To replace the palm rests, insert the tabs on the inside edge of the palm rest into the slots on the computer. Then press along the outside edges of the
palm rest until it snaps into place.
Repeat the process on each side.
Display Cover
1.
Slide your index fingers under the straight edge of the display cover until the cover pops out.
HINT:
Complete instructions for installing the palm rests are included with the optional color inserts.
HINT:
Complete instructions for installing the display cover are included with the optional color inserts.