Cards, Installing a card – Dell Precision 650 User Manual
Page 28
Back to Contents Page
Cards
Dell Precision™ Workstations 450 and 650 User's Guide
Your Dell™ computer provides slots for PCI/PCI
-X and AGP cards. For more information, see "
Specifications
" or the system board components illustration for
your computer.
1.
Shut down the computer through the Start menu.
2.
Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut
down your computer, turn them off now.
3.
Disconnect any telephone or telecommunication lines from the computer.
4.
Disconnect your computer and all attached devices from electrical outlets, and then press the power button to ground the system board.
5.
If you have installed a padlock through the padlock ring on the back panel, remove the padlock.
6.
Open the computer cover
.
Installing a Card
1.
Press the lever on the card retention arm and raise the retention arm.
NOTE:
To meet PC99 requirements, your Dell computer uses only PCI slots. ISA cards are not supported.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTICE:
Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the
computer. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components.
CAUTION:
Before you perform this procedure, follow the safety instructions in the System Information Guide.
1
lever
2
retention arm