Dell PowerVault DL2200 - Manual (Page 19)

Symantec Corporation World Headquarters
20330 Stevens Creek Blvd., Cupertino, CA 95014 USA
+1 (408) 517 8000 / +1 (800) 721 3934
www symantec com
© 2008 Symantec Corporation. All rights reserved. Symantec and the Symantec logo are trademarks or registered trademarks of Symantec Corporation or its affiliates in the U.S. and other countries.
Other names may be trademarks of their respective owners.
Figure: Continuous Protection Server Getting Started Screen
This document is not intended to cover the installation of Continuous Protection Agents. Please refer to the Backup
Exec Continuous Protection Server Administrator’s Guide for information on installing agents.
Backup destinations must be setup before backup jobs can be configured. From the Getting Started Screen, select
Step 2 – Create Backup Destinations. The Backup Destination Wizard will appear.
1. Click Next to continue.
2. Enter a name and description for the backup destination. This information is used to help uniquely identify
the backup destination. Click Next to continue.
3. Backup destinations can be stored on systems where the continuous protection agent or management
service has been installed. In this example, the destination will be stored on the PowerVault DL Backup to
Disk Appliance. Select the computer name in the Computer dropdown of the PowerVault DL Backup to Disk
Appliance. Click Next to continue.
4. Determine the path on the computer where the data will be stored. If a Backup Exec Virtual Disk is being
used to store the data, it is recommended that the data be stored in the CPS Data (or similar folder) created
on the virtual disk in the previous section. Do not store the data in the BEControl or BEData folders that are
present on the Backup Exec Virtual Disk. Note: Remember the path as it will be needed later as part of the
seeding process.