Crestron electronic Isys TPS-17W - Manual (Page 56)

ISYS ® TILT TOUCHPANELS
Isys ® Tilt Touchpanel Accessories
www.crestron.com | 800.237.2041 | 201.767.3400
© 2007 Specifications subject to change without notice
tilt touchpanels
INTERFACE MODULES AND CABLES
TPSBLOCK-10 10-Pin Connector Block for Isys ® Tilt Touchpanels
The TPSBLOCK-10 provides a simplified connectivity
solution for Isys TPS-3000 and TPS-4000 tilt touch-
panels. This chassis-mount 10-pin RJ45 jack is suitable
for installation on any custom panel, or in standard
adapter plates offered from other manufacturers. An
integral 10' cable is included, terminated at the other
end with a 10-pin RJ45 male connector.
The TPSBLOCK-10 is compatible with Crestron
TPS-IMPC and TPS-4500IMPC interface modules,
allowing the installer to hide the interface module
beneath a tabletop or inside a lectern while providing
a convenient, clean-looking connection above surface
for the touchpanel.
SPECIFICATIONS
Connectors
(1) 10-pin RJ45 female, chassis-mount, shielded
(1) 10-pin RJ45 male, shielded
Length
10 ft (3.05 m)
56
ST-PK Programming Cable Kit
It is used only for loading touchpanel files, updating
firmware, and configuring the touchpanel prior to
operation. The ST-PK may also be used to update
firmware and adjust the digital audio signal processing
in Crestron’s 7.1 surround sound processors and
room solution boxes.
SPECIFICATIONS
Cables
3.5mm to RJ11 Cable Assembly (CNSP-585):
Provides connection between a SmarTouch wireless
touchpanel and the control processor via a RJ11 Cresnet
port; may require an additional CNRJ11 , ST-CNB, or
C2N-HBLOCK accessory.
RJ11-to-RJ11 Cable plus RJ11-to-DB9F Adapter
(STCP-502):
Provides connection between an Isys touchpanel,
surround processor, or room solution box RS-232 port and
PC COM port.