Enabling the infrared sensor – Dell Inspiron 4100 User Manual
Page 26
26
Se t t i n g U p
w
w
w
.dell.com |
su
pport.de
ll.com
In Microsoft Windows Me
1
Right-click the Softex BayManager icon on the Microsoft Windows
taskbar.
2
Click Remove/Swap.
3
Wait a few seconds until the device is ready to be ejected.
4
Keep the display open, and tilt the computer back so that you can
access the bottom of the computer.
5
Slide and hold the latch release, and pull the device out of the module
bay.
6
Insert the new device into the bay, and push it until you hear a click.
7
Click OK. Then click OK again to close the Softex BayManager
window.
In Microsoft Windows 2000
1
Double-click the Unplug or Eject Hardware icon on the Microsoft
Windows taskbar.
2
Click the device you want to eject and then click Stop.
3
Click OK, and wait until the device you want to eject is cleared from
the list of devices in the Unplug or Eject Hardware window.
4
Keep the display open, and tilt the computer back so that you can
access the bottom of the computer.
5
Slide and hold the latch release, and pull the device out of the module
bay.
6
Insert the new device into the bay, and push it until you hear a click.
7
When Windows recognizes the new device, click Close.
Enabling the Infrared Sensor
HINT:
You cannot use the
infrared sensor when the
computer is docked.
1
Turn on your computer, and enter the system setup program by
pressing
when the Dell™ logo appears.
2H767bk0.book Page 26 Friday, September 28, 2001 1:37 PM