Cisco 10008 User Manual
Page 23
23
Cisco 10008 Router Performance Routing Engine 3 Installation
OL-8544-01
Upgrading Software
256503808 bytes total (230752256 bytes free)
Router# dir stby-disk0:
Directory of stby-disk0:/
1 -rw- 25750196 Mar 4 2000 00:14:56 +00:00 c10k3-p11-mz
257544192 bytes total (231792640 bytes free)
Step 5
Display the system image on bootflash.
Router# show run | i boot
boot-start-marker
boot system flash disk0:c10k3-p11-mz.mce_rp_isp-20060127
boot-end-marker
exception crashinfo file bootflash:crashinfo
Step 6
Enter global configuration mode.
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Step 7
Remove the current image from bootflash in Disk0.
Router(config)# no boot system flash disk0:c10k3-p11-mz.mce_rp_isp-20060127
Step 8
Add the new image to bootflash in Disk0.
Router(config)# boot system flash disk0:c10k3-p11-mz
Step 9
Set the contents of the software configuration register to 0x2100. This new register setting will take
affect after the system reload in
Router(config)# config-register 0x2100
Step 10
Return to privileged EXEC mode.
Router(config)# exit
Router#
Step 11
Copy the running configuration to the startup configuration.
Router# copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
[OK]
Step 12
Verify the running configuration is copied to the startup configuration on both PRE3s.
Router# show bootvar
BOOT variable = disk0:c10k3-p11-mz,1;
CONFIG_FILE variable =
BOOTLDR variable =
Configuration register is 0x0
Standby BOOT variable = disk0:c10k3-p11-mz,1;
Standby CONFIG_FILE variable =
Standby BOOTLDR variable =
Standby Configuration register is 0x0
Step 13
Reload the system by entering the reload command.
Router# reload
Proceed with reload? [confirm]