Cisco 10008 - Manual (Page 28)

28
Cisco 10008 Router Performance Routing Engine 3 Installation
OL-8544-01
Analyzing and Troubleshooting Packets
For detailed information about the show pxf cpu commands, refer to the Cisco 10000 Series Router
Broadband Aggregation, Leased-Line, and MPLS Configuration Guide.
To display packet statistics for the PRE3, enter the following commands:
Command Purpose
Router# show running-config Displays the current router configuration.
Router# show interfaces type slot/subslot/port Displays information about an interface.
Router# show version Displays information about the currently
loaded software version along with hardware
and device information.
Router# show pxf cpu access-lists Displays PXF memory information for ACLs.
Router# show pxf cpu atom Displays PXF Any Transport over MPLS
(AToM) forwarding information for an
interface or Virtually Cool Common Index
(VCCI).
Router# show pxf cpu bba Displays PXF Broadband Aggregation (BBA)
groups information.
Router# show pxf cpu buffers Displays packet buffer memory for temporary
packet storage in the Cisco Internetwork
Performance Monitor (IPM) of the PXF.
Router# show pxf cpu context Displays the current and historical loads on
the PXF.
Router# show pxf cpu feedback Displays the total number of feedbacks
through the PXF by all packets.
Router# show pxf cpu isg Displays PXF policy and template
information.
Router# show pxf cpu ipv6 Displays PXF IPv6 statistics.
Router# show pxf cpu mpls Displays PXF MPLS Forwarding Information
Base (FIB) information.
Router# show pxf cpu mroute Displays PXF multicast route (mroute)
information for a particular group or range of
groups.
Router# show pxf cpu pbr action Displays policy-based routing (PBR) actions
configured in the PXF.
Router# show pxf cpu police Displays all active policer policies in the PXF,
including active interface and policing
parameters.
Router# show pxf cpu policy-data Displays PXF policy data index usage
statistics.
Router# show pxf cpu queue Displays queueing statistics for a single
interface, all interfaces, or a queue identifier
(QID).
Router# show pxf cpu statistics Displays various PXF statistics for a
configured router.