Cisco 10008 - Manual (Page 7)

7
Cisco 10008 Router Performance Routing Engine 3 Installation
OL-8544-01
Prerequisites and Preparation
Prerequisites and Preparation
Before you perform any of the procedures in this guide, we recommend that you:
• Read the safety guidelines in the next section and review the electrical safety and ESD-prevention
guidelines as described in the hardware installation guide for the Cisco 10008 router.
Cisco 10008 Router Hardware Installation Guide
http://www.cisco.com/univercd/cc/td/doc/product/aggr/10000/hdwr/8-hig/index.htm
• Ensure that the software configuration meets the minimum requirements for the installation (see the
“Software Compatibility” section on page 8 ).
• Ensure that you have all of the necessary tools and equipment before beginning the installation (see
the
“Installation Guidelines” section on page 8 ).
• Have a terminal console connected to the PRE3 to configure the PRE3 after it is installed.
The following documents may be used as reference material while performing procedures in this
document:
– Cisco 10000 Series Router Performance Routing Engine Installation
http://www.cisco.com/univercd/cc/td/doc/product/aggr/10000/hdwr/index.htm
– Cisco 10000 Series Internet Router Troubleshooting Guide
http://www.cisco.com/univercd/cc/td/doc/product/aggr/10000/tblshoot/trblgd/index.htm
Safety Guidelines
Before you begin the PRE3 installation procedure, review the safety guidelines in this section to avoid
injuring yourself or damaging the equipment. Before you install, configure, or perform maintenance on
the router, you should also review the safety warnings listed in the
Regulatory Compliance and Safety
Information for Cisco 10000 Series Routers document.
Safety Warnings
Safety warnings appear throughout this publication in procedures that, if performed incorrectly, may
harm you. A warning symbol precedes each warning statement. The following warning is an example of
a safety warning. It identifies the warning symbol and associates it with a bodily injury hazard.
Warning IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Note If you need translations of the safety warning, see the Regulatory Compliance and Safety Information
for Cisco 10000 Series Routers document.