Dell Inspiron Mini 10 (1012, Late 2009) User Manual
Page 32
Back to Contents Page
Memory Module
Dell™ Inspiron™ 1012 Service Manual
You can increase your computer memory by installing memory modules on the system board. See "Basic Specifications" in your Setup Guide or the
Comprehensive Specifications at support.dell.com\manuals for information on the type of memory supported by your computer.
Your computer has one user-accessible SODIMM connector.
Removing the Memory Module
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Loosen the screw that secures the memory module cover to the palm rest assembly.
5.
Slide the memory module cover tabs out of the slots on the palm rest assembly.
6.
Lift the memory module cover off the palm rest assembly.
7.
Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the memory module pops up.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
1
memory module cover
CAUTION:
To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.