Raid level 1 configuration, Configuring your hard drives for raid, Using the nvidia mediashield rom utility – Dell OptiPlex 740 User Manual
Page 15
RAID Level 1 Configuration
RAID level 1 uses a data-redundancy storage technique known as mirroring to enhance data integrity. When data is written to the primary drive, the data is
also duplicated, or mirrored, on the second drive in the configuration. A RAID level 1 configuration sacrifices high data-access rates for its data redundancy
advantages.
If a drive failure occurs, subsequent read and write operations are directed to the surviving drive. A replacement drive can then be rebuilt using the data from
the surviving drive.
Configuring Your Hard Drives for RAID
Your computer can be configured for RAID, even if you did not select a RAID configuration when the computer was purchased. For an explanation of RAID levels
and their requirements, see
. For information on how to install a hard drive, see
Installing a Hard Drive
for your mini tower computer
or
Installing a Hard Drive
for your desktop computer.
You can use one of two methods to configure RAID hard drive volumes. The first method uses the NVIDIA MediaShield ROM utility and is performed before you
install the operating system onto the hard drive. The second method uses NVIDIA MediaShield and is performed after you have installed the operating system
and NVIDIA RAID drivers.Both methods require that you set your computer to RAID-enabled mode before you begin.
Setting Your Computer to RAID-Enabled Mode
1.
2.
Press the up- and down-arrow keys to highlight Drives, then press <Enter>.
3.
Press the up- and down-arrow keys to highlight the applicable SATA drive, then press <Enter>.
4.
Press the left- and right-arrow keys to highlight RAID On, and then press <Enter>. Repeat the process, as needed, for each SATA hard drive.
5.
Press <Esc>, press the left- and right-arrow keys to highlight Save/Exit, and then press <Enter> to exit system setup and resume the boot process.
Using the NVIDIA MediaShield ROM Utility
Hard drives of any size may be used to create a RAID configuration. Ideally, however, the drives should be of equal size to avoid unallocated or unused space.
For an explanation of RAID levels and their requirements, see
About RAID Configurations
. For information on how to install a hard drive, see
Installing a Hard
Drive
for your mini tower computer or
Installing a Hard Drive
for your desktop computer.
1.
Enable RAID for each applicable hard drive on your computer (see
Setting Your Computer to RAID- Enabled Mode
2.
Restart the computer.
NOTE:
In a RAID level 0 configuration, the size of the configuration is equal to the size of the smallest drive multiplied by the number of drives in the
configuration.
NOTE:
In a RAID level 1 configuration, the size of the configuration is equal to the size of the smallest drive in the configuration.
NOTE:
For more information about RAID options, see
.
NOTICE:
The following procedure will result in the loss of all data on your hard drive(s). Back up any data you want to keep before continuing.
Do not use the following procedure to migrate an existing RAID configuration. See