Dell OptiPlex 740 - Manual (Page 99)

5. Connect any cables that should be attached to the card.
6. Before you close the card retention mechanism, ensure that:
l The tops of all cards and filler brackets are flush with the alignment bar.
l The notch in the top of the card or filler bracket fits around the alignment guide.
7. Secure the card(s) by closing the card retention latch and snapping it into place.
8. Replace the computer cover (see Replacing the Computer Cover ).
9. If you installed a sound card:
1 PCI Express x16 card 2 PCI Express x16 card connector
1 PCI Express x16 card 2 DVI-card connector 3 PCI Express x16 card connector
1 fully seated card 2 not fully seated card 3 bracket within slot
4 bracket caught outside of slot
NOTICE: Do not route card cables over the cards. Cables routed over the cards can prevent the computer cover from closing properly or cause damage
to the equipment.