D to change the sequence of other devices, E press <esc> to exit – Dell PowerEdge RAID Controller S300 User Manual
Page 41
Installing the Drivers
41
6
Change the Boot
Priority List
for Devices (if
applicable)
To change the order of the devices (CD-ROM, optical
DVD, and so on), perform the following:
NOTE:
Unless mentioned otherwise, the term PERC Virtual
Disk Management utility refers to both the PERC S100 Virtual
Disk Management utility and the PERC S300 Virtual Disk
Management utility.
NOTE:
If the PERC Virtual Disk Management utility is open,
select Continue to Boot, then press <Enter>. Press
<Ctrl><Alt><Delete> to reboot the system.
a
Boot the system. When the POST screen appears,
press <F2>.
b
At the Dell PowerEdge System screen, use the arrow
keys to scroll to Boot Sequence. Press <Enter>.
c
Make sure that Hard drive C: is the first device
listed.
d
To change the sequence of other devices:
•Use the <+> key to move devices up, or the <-> key
to move devices down.
•Use the space bar to enable or disable a device.
e
Press <Esc> to exit.
f
Press <Esc> again. Select Save Changes and
Exit and press <Enter>.
NOTE:
Continue with one of the following procedures:
• "Installing the Controller Drivers During the Operating
System Installation: For Systems with a PERC S100
• "Installing the Controller Drivers During the Operating
System Installation: For Systems with a PERC S300
Table 5-2. Pre-Installation Procedures For The Controller Drivers
(continued)
Procedure
Steps
A5_bk0.book Page 41 Thursday, February 10, 2011 8:34 PM