Dell Vostro 2510 (Early 2009) - Manual (Page 49)

Back to Contents Page
Palm Rest
Dell™ Vostro™ 2510
Service Manual
Removing the Palm Rest
Replacing the Palm Rest
Removing the Palm Rest
CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
1. Follow the instructions in Before Working on Your Computer .
2. Remove the hard drive cover. See Removing the Hard Drive for an illustration of the hard drive cover.
3. Remove any cards or blanks installed in the ExpressCard slot and the 8-in- 1 card slot.
4. Remove the WLAN card (see Removing a WLAN Card ).
5. Remove the hinge cover (see Removing the Hinge Cover ).
6. Remove the keyboard (see Removing the Keyboard ).
7. Remove the display assembly (see Removing the Display Assembly ).
8. Remove the M2.5 x 5-mm screw labeled with a "P" from the fan.
9. Remove the fourteen M2.5 x 8-mm screws from the bottom of the computer.
NOTE: The screw locations may vary slightly from the image shown below.
10. Turn the computer over and remove the three M2.5 x 5-mm screws that secure the top of the palm rest.