Dell Inspiron One 2205 (Mid 2010) User Manual
Page 28
1.
Follow the instructions in
Before You Begin
.
2.
Clean the thermal grease from the bottom of the processor heat-sink and reapply it.
3.
Align the four captive screws on the processor heat-sink with the screw holes on the system board and tighten the screws in sequential order (indicated
on the processor heat-sink).
4.
Replace the two screws that secure the processor heat-sink to the chassis.
5.
Replace the processor heat-sink fan (see
Replacing the Processor Heat-Sink Fan
).
6.
Replace the MXM assembly (see
Replacing the MXM Assembly
).
7.
Replace the MXM-assembly fan (see
Replacing the MXM-Assembly Fan
).
8.
Replace the system-board shield (see
Replacing the System-Board Shield
).
9.
Replace the rear stand cover (see
Replacing the Rear Stand Cover
).
10.
Follow the instructions from
step 4
to
step 7
in
Replacing the Front Stand
.
11.
Replace the back cover (see
Replacing the Back Cover
).
12.
Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
CAUTION:
Incorrect alignment of the processor heath-sink can cause damage to the system board and processor.
NOTE:
The original thermal grease can be reused if the original processor and processor heat-sink are reinstalled together. If either the processor or
the processor heat-sink is replaced, use the thermal grease provided in the kit to ensure that thermal conductivity is achieved.
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.