Dell Inspiron One 2205 (Mid 2010) - Manual (Page 33)

Back to Contents Page
Infrared Blaster Connector (Optional)
Dell™ Inspiron™ One 2205 Service Manual
Removing the Infrared (IR) Blaster Connector
Replacing the Infrared (IR) Blaster Connector
Removing the Infrared (IR) Blaster Connector
1. Follow the instructions in Before You Begin .
2. Follow the instructions from step 2 to step 9 in Removing the System-Board Shield .
3. Remove the nut that secures the IR blaster to the system-board shield.
4. Release the IR blaster connector from the slot on the system-board shield.
5. Lift the IR blaster connector along with its cable away from the system-board shield.
Replacing the Infrared (IR) Blaster Connector
1. Follow the instructions in Before You Begin .
2. Slide the IR blaster connector into the slot on the system-board shield.
3. Replace the nut that secures the IR blaster connector to the system-board shield.
4. Follow the instructions from step 4 to step 11 in Replacing the System-Board Shield .
5. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1 IR blaster connector 2 nut
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.