Dell OptiPlex GX200 - Manual (Page 46)

Figure 14. New Drive Insertion
NOTICE: You must match the colored strip on the cable with pin 1 on the drive's interface connector to avoid possible damage to
your system.
8. Connect a DC power cable to the power input connector on the back of the drive (see Figure 15).
Figure 15. 5.25-Inch Drive Cables Attachment
9. Connect the appropriate EIDE interface cable to the EIDE interface connector on the back of the drive (see Figure 15).
If your system came with an EIDE CD-ROM or tape drive, use the spare connector on the existing interface cable. Otherwise, use the EIDE
interface cable provided in the drive kit.
Hard-Disk Drive Removal
Figure 16. Hard-Disk Drive Bracket Removal
1 5.25-inch drive
1 DC power cable
2 EIDE interface connector (on drive)