Dell OptiPlex GX200 - Manual (Page 74)

Expansion Cards
The small form-factor GX200 chassis can accommodate up to two half-length 32-bit PCI expansion cards. Figure 22 shows an example of a 32-bit
PCI expansion card.
Figure 22. 32-Bit PCI Expansion Card Example
Expansion Card Removal
To remove an expansion card, perform the following steps:
1. Remove the computer cover .
2. If necessary, disconnect any cables connected to the card.
3. Remove the expansion-card cage .
4. Remove the screw on the mounting bracket of the card you want to remove.
5. Grasp the card by its outside corners, and ease it out of its connector.
6. If you are removing the card permanently, install a metal filler bracket over the empty card-slot opening.
7. Replace the computer cover , and reconnect your computer and peripherals to their electrical outlets and turn them on.
8. Reset the chassis intrusion detector .
Figure 23. Expansion Card Installation
MOUSE Mouse connector
PANEL Control panel connector
PARALLEL Parallel port connector; sometimes referred to as LPT1
PCIn* PCI expansion-card connector
POWER_1 Main power input connector
POWER_2 3.3-V power input connector
RISER Riser board connector
SERIALn Serial port connector
SLOT1_PRI Primary microprocessor connector
USB USB connectors
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain Federal Communications Commission (FCC)
certification of the system. The brackets also keep dust and dirt out of your computer.